nanoDLP

Yianni-VJ

Member

Registered: 2016-05-24

Posts: 95

Over or Under Exposed?

Can I get some advice about fine tuning my prints?

My printer is a bottom up, focused at 40um in XY and 25um in Z axis.
Antialias enabled.
The hole in the picture below is .5mm diameter.
The resin used is B9 Emerald, which has additives to facilitate castability, but makes it a little harder to print fine details compared to crisper resins.

To get a rounder hole, should I increase or decrease exposure times?

Last edited by Yianni-VJ (2017-10-14 10:16:28)

Yianni-VJ

Member

Registered: 2016-05-24

Posts: 95

Re: Over or Under Exposed?

Oops, sorry...
I update the post, thanks for the heads up!