You are not logged in.

#1 2022-12-13 13:46:22

fran42
Member
Registered: 2020-11-16
Posts: 70

NANODLP not working

Hi,

Las week the nanodlp was working perfectly working on the raspberry for 3D printing.
Today I started the raspberry and got this message:

Please choose a distribution. Mask, defaut seting files and etc will be deployed.
- If you want to overonte settings too, alter restart go to "Setup' page / "Tools" lab and press 'Restore
Sellinos' buton.
Channe to "nanoDLP generic* Version
Change to *ynde" Version
Change to "Phrozen" Version
Change to "mUVe30* Version
Change to "Microlay* Version


And there is nothing I can do to access my plates, or to see my resin profiles… When I choose one version it reestarts but I got the same screen again asking me to choose version.

It is like it erased all the information or something like that? Is that possible if no one touched the system? Any idea what is going on?

Any help would be very appreciated.

Offline

#2 2023-01-19 11:38:22

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: NANODLP not working

System corruption can cause this (SD card).

It is highly probable your files are fine, just ssh into pi and checkout /home/pi/printer/db/ folder

Offline

Board footer

Powered by FluxBB