You are not logged in.

#1 2022-06-23 17:52:04

elliot
Member
Registered: 2016-04-28
Posts: 109

mUVe and Marlin Version 2.0

Is there a tutorial help for 2.0.5? I upgraded to the nanodlp marlin for my mUVe, which has a dual z motor and rails. I had it working on the old Marlin V1, but the new version does not work. I confirmed I am using the correct nanodlp version from git, also tried Marlin from git, eeprom settings, and that the active motor (z) can be switched to either lead screw and works fine. The problem is the E0 motor is no longer triggered to move with the Z1. I am happy to post configuration.h and configuration_adv.h to help solve the issue. I am sure it is my fault and a simple code error somewhere...Thank you forum!

Offline

Board footer

Powered by FluxBB