nanoDLP

CERBERO

Member

Registered: 2017-01-23

Posts: 2

HOW TO SYNCRONIZE

Hi i'm new whith DLP printing and nanodlp. I have a wasp topdlp printer.

I have some trouble with the motion. what i need to do is: from the home position go into the resin jar to bring the resin, then lift up the plane in printing position and expose; then stop exposing, move the plate into the jar, lift the plate up again and expose.
can someone help me? thanks

jamesarm97

Member

Registered: 2017-02-02

Posts: 69

Re: HOW TO SYNCRONIZE

What firmware does it use? I had the same problem with the D7 using sprinter or something like that so I modified Repetier to support the nanodlp z_move_comp command then you can wait for those return responses before going to the next step or exposing a layer.