nanoDLP

garrett

Member

Registered: 2018-09-18

Posts: 1

nanodlp access problem

Hi, I installed nanodlp with Advanced Installation option.

In fact, I did not understand the correct installation method,
so before install nanodlp, I connected the RPi to the router through the wireless LAN and assigned a fixed IP address.
The fixed address is 172.30.1.100.

So before installing nanodlp, I could connect to PuTTY without any problems.

This is happening at boot after installing nanodlp.
I think it's not problem. www nanodlp com/forum/viewtopic.php?Id=104

However, after installing nanodlp, putty connection is not possible to the fixed ip address.
Connection via browser is also the same.

To point out the problem with my installation process that I can present,
I pressed y all because I did not get a clear understanding of the choices that come out of the installation process.
This seems to be the biggest mistake.

Is it the right way to do the following?
www nanodlp com/forum/viewtopic.php?id=185

And power adapter I use for RPi is 5v 2a. If what I presented is not a problem, this is a power problem?

And my RPi is 3B+

I'm sorry I'm not good at English.
I hope you can understand my question.

Last edited by garrett (2018-09-18 16:41:33)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,544

Re: nanodlp access problem

You probably have made IP static by pressing Y on the advanced setup.