nanoDLP

Jose_eurecat

Member

Registered: 2018-01-05

Posts: 6

The piece doesn't get hooked for one side

Somebody can help me pls? the piece doesn't get hooked for one side. At the beginning the part is printed on the build plate but after some layers the weight makes unhook of the build plate for one side ( I think). I have attached some pictures so you can see the result of what i say. I have tried different printing parameters. I leave attached the print parameters that I have used for these pieces

Jose_eurecat

Member

Registered: 2018-01-05

Posts: 6

Re: The piece doesn't get hooked for one side

Printer profile                                              Res                                                               burn in layers                                                                     normal layers

ex: mUVe 3D SubSF Red XY75_prova2    75(resolution)    3 (number of layers)    25(Layer thickness)     125(cure time)                 52 (Layer thickness)                  25(cure time)

mUVe 3D SubSF Red XY75                        75    2    100    50        100    9,2
mUVe 3D SubSF Red XY75_prova3        75    3    62,5    87,5        76    17,1
mUVe 3D SubSF Red XY75_prova4        75    3    62,5    87,5        50    10
mUVe 3D SubSF Red XY75_prova5        75    3    62,5    87,5        125    25
mUVe 3D SubSF Red XY75_prova42             75    3    62,5    87,5        50    15
mUVe 3D SubSF Red XY75_prova6            75    20    50    75        75    15

Jose_eurecat

Member

Registered: 2018-01-05

Posts: 6

Re: The piece doesn't get hooked for one side

Picture here!!

https://drive.google.com/open?id=1znZT9 … RJveAZoJvZ

Jose_eurecat

Member

Registered: 2018-01-05

Posts: 6

Re: The piece doesn't get hooked for one side

now you can see where the constrution plate is:
https://drive.google.com/open?id=1znZT9 … RJveAZoJvZ

elshad66

Member

Registered: 2017-03-31

Posts: 120

Re: The piece doesn't get hooked for one side

these three printed in one place or in different?
build  plate calibrated horizontally with respect to the screen?

Jose_eurecat

Member

Registered: 2018-01-05

Posts: 6

Re: The piece doesn't get hooked for one side

There were 3 different impressions.
Yes, I did the horizontal calibration. The vat is level correctly
Something strange is happening
help pls

elshad66

Member

Registered: 2017-03-31

Posts: 120

Re: The piece doesn't get hooked for one side

Check the layers, maybe the model is crooked, on the table
at the beginning prints the left part, and then the right one